Можно ли самому перепрагромировать ключ на RX300. А то сломалась кнопка, а я нашёл другой ключ. Кто с этим сталкивался ? Или где сделать и сколько стоит ?
можно.
но если нет опыта, видел как алгоритм 40 минут осваивали
тестером на сервисе гораздо проще, быстрее и стоит копейки.
главное тестером наглядней видно - сколько ключей в памяти и быстро можно постирать лишние.
Key Programming
1. Insert an already programmed master key into the ignition. Do not turn.
2. Press and release the gas pedal 5 times.
3. Press and release the brake pedal 6 times.
4. Remove the key from the ignition.
5. Insert the new key you want to program into the ignition.
6. Press and release the gas pedal one time.
7. Wait 1 minute. The security light will be blinking for this one minute. When it stops blinking your key is programmed. To end programming step on brake one time.
Remote Programming
1. Close and lock all doors. Unlock and open drivers door.
2. Put key into ignition and remove. Do not turn it on.
3. Using the electric lock switch. Lock and unlock 5 times.
4. Close and open drivers door.
5. Using the electric lock switch. Lock and unlock 5 times.
6. Put key into ignition. Turn to "ON" , turn off and remove.
7. You will see the door locks cycle by themselves.
8. On the remote, press and hold the LOCK and the UNLOCK button at the same time for 2 seconds.
9. On the remote, press the LOCK button for 1 second.
AT THIS POINT, the locks should cycle by themselves ONE time. This means the procedure was accepted. IF the locks cycle twice it has failed. IF this happens you must start over. Hold the remotes higher up for better reception.
10. Close and open door to end programming procedure
Вот ты злой. Все понятно, но в п. 7 написано:Wait 1 minute. The security light will be blinking for this one minute. When it stops blinking your key is programmed. To end programming step on brake one time.
Подождите минуту, индикатор типа помигает в течение минуты и когда он закончит мигать, твой ключ типа готов. Жми на тормоз раз и все ОК.
А что зпрограммирование remotа ?
Это что за зверь?
программирование ключа - ясно. + у меня есть от поставщика последовательность почти такая , но чуть с дополнениями для надежности и с проверкой сколько ключей в системе. (Так и опробовал все болванку не успеваю нарезать).
? Где ХОРОШО И КАЧЕСТВЕННО нарежут болванку ключа для лекса Подскажите хорошее место.